I went to Balzer Elektronic to get some pieces. Only got the 15-way IDC, a fan, and some microswitches.
The microswitches are the wrong size.
Fastened the fan in the fan holder, no problem.
The IDC is correct, but the ribbon cable I have is a very colorful one that apparently is just meant to be a supply of single cables. It is just a little bit off the size of a regular ribbon cable. Good thing I noticed before I squeezed the IDC.
Also, I found my Melzi.
Subscribe to:
Post Comments (Atom)
-
I've had the worst time with my PETG filament, test prints literally exploding during the print and finished prints being very brittle. ... -
With my new pretty hobbed bolt mounted, I attempted a little extrusion. Unfortunately, all that happened was that the gear end started unscr... -
After last weekend's fiasco, I've decided to take my extruder apart, at least enough to see if there are any obvious signs of block...
No comments:
Post a Comment