Wednesday 2 September 2009

Working power supply

Briefly tested the new power supply, and it works with a big resistor on 5V. Lights up the stepper motor driver bicolor led somewhat prettily. Tomorrow: Rewire the stepper motors according to some hint I got from another Sanyo user.
at
Labels: ,

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)
  • Dehumidifying methods
    I've had the worst time with my PETG filament, test prints literally exploding during the print and finished prints being very brittle. ...
  • New bolt, new problems.
    With my new pretty hobbed bolt mounted, I attempted a little extrusion. Unfortunately, all that happened was that the gear end started unscr...
  • Unclogging failure
    After last weekend's fiasco, I've decided to take my extruder apart, at least enough to see if there are any obvious signs of block...