Saturday 13 June 2009

Tip for drilling pipes

I don't have a drill press yet. I want one, but can't afford to get one that I trust to be of OK quality. So drilling into pipes is tricky, the drill moves off the spot even worse than when drilling on flat surfaces. At the last hole (of course:) I hit on the trick of taking the metal saw and making a little X centered on where the holes should be. Voila, no more drill movement.
at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)
  • Dehumidifying methods
    I've had the worst time with my PETG filament, test prints literally exploding during the print and finished prints being very brittle. ...
  • New bolt, new problems.
    With my new pretty hobbed bolt mounted, I attempted a little extrusion. Unfortunately, all that happened was that the gear end started unscr...
  • Unclogging failure
    After last weekend's fiasco, I've decided to take my extruder apart, at least enough to see if there are any obvious signs of block...