With some help from a Norwegian friend, I have made significant progress.
I have the rails for the X frame bolted onto the end pieces.
I have the X stage acrylics mounted with nut and sliders (though I need to wrap some teflon around the sliders).
I have tested and fixed a soldering issue on one of the stepper drivers, it now works for all I can tell.
I have gotten an Ethernet cable that can actually communicate with the opto endstops.
I have tested the opto endstops, and found that they work... on and off. And not in the manner I expected.
I still need some way to connect the threaded rod to the motor, I figure duct tape will do for testing purposes. I am also out of solder.
Subscribe to:
Post Comments (Atom)
-
I've had the worst time with my PETG filament, test prints literally exploding during the print and finished prints being very brittle. ... -
With my new pretty hobbed bolt mounted, I attempted a little extrusion. Unfortunately, all that happened was that the gear end started unscr... -
After last weekend's fiasco, I've decided to take my extruder apart, at least enough to see if there are any obvious signs of block...
No comments:
Post a Comment